SERIES 400owners manualPure Drinking Water Appliance
10 | installation instructionsPlease follow all of the installation steps below. If you have any questions, don’t hesitate to contact us at 844-DRINK
| 11Step 9 | Chilling and heatingthe water tanksAfter flushing, turn the hot and coldcompressors on by flipping theswitches to the on or “I” position
12 | cleaning and maintenanceWARNING: To reduce the risk of fire or electrical shock, unplug your Series 400 and turn off the water supply underthe s
| 13troubleshootingWARNING: To reduce the risk of fire or electrical shock, unplug your Series 400 and turn off the water supply underthe sink before
Ordering replacement filtersTo maintain the highest quality water your Drinkpod canprovide, your filter should be replaced every 6-8 months or1200 gal
LIMITED WARRANTY TERMS AND CONDITIONS TWO YEARS ON PARTS, AND THREE YEARS ON COMPRESSOR FROM DATE OF PURCHASEThis warranty is “limited” to any Drinkpo
844-DRINKPOD (844-374-6576)drinkpodusa.com
contentsintroduction | 3safety reminders | 4getting to know your Series 400 | 6installation notes | 7installation instructions | 8cleaning and ma
This manual provides instructions for installing and maintaining your Drinkpod Series 400.IMPORTANT: Please do not store your Series 400 where it can
4 | safety remindersWhen using your Series 400, take steps to reduce the risk of fire, electric shock, and/or injury byfollowing these safety precaut
| 5 Do not clean any parts with anything other than mildsoap and water and a non-abrasive cloth. Avoid contact with moving parts. Do not place cloth
getting toknow yourSeries 400 Auto Shut Off (In Case of Emergency) Bottom Load Drip Tray Compartment Built In Leak Detector Drip Tray Filling Sensor D
| 7 Choose a location for your Series400 that is away from directsunlight, excessive heat and/orcold, and wetness. Make sure there is at least 3” ofs
Step 1 | Install the saddle valveat cold water sourceTo connect the feed water, first shutoff the water line under your sink.Then use the supplied sel
| 9Step 4 | Hook up the water supplyOnce the tubing is placed securely,connect one end to the saddle valveand the other end to the water sourceinlet
Comments to this Manuals